From Makers Local 256
Revision as of 15:51, 1 November 2011 by Enabrintain
This page is a Research page for hanging data on Laser Cutting.
Laser Diode Cutting
- The guy at Buildlog is my hero.(Mach3 Laser Cutter Setup)
- This page shows how to convert gCode to a signal on pin one of the parallel port.
- I will need to divert pin 1 or possibly look for where it goes on the motor driver board.
- PCB Stencil Materials
- This page seems to be exhaustive regarding the construction of low amperage diode laser drivers.
SrsBizness Laser Cutting
- wherein the amps become numerous...
- not there yet