Difference between revisions of "Omegix/USB Auth 1.7/Enclosure"

From Makers Local 256
Jump to: navigation, search
(creating page for enclosure)
 
m (added steps)
Line 8: Line 8:
 
* Using Inkscape
 
* Using Inkscape
 
* Using Makeshop's laser cutter: Max Cutting Dimensions are 14 x 9 "
 
* Using Makeshop's laser cutter: Max Cutting Dimensions are 14 x 9 "
 +
 +
== Procedure ==
 +
# Opened PDF obtained from boxmaker website in Inkscape
 +
# Deleted the extraneous text
 +
# Selected all and did the line draw thing
 +
# Doesn't matter what the canvas size is in Inkscape, Raster Engrave is where that matters
 +
# Print to Raster Engrave
 +
# Set Settings to Speed:20, Power:100, Passes:3
 +
# Put painters tape on both sides of the acrylic
 +
# Make sure laser is up to 15mA
 +
# Press "P" 4 times to outline the perimiter
 +
# "Notch the corners with the laser's two fire buttons
 +
# Press Play

Revision as of 18:10, 1 October 2013

This page is for the creation of the Project Enclosure for the USB Auth 1.7 project.

  • Materials
    • 1/8 Inch Clear Acrylic.
      • 8 x 4.5 x 2.5 "
  • Project Files
  • Using Inkscape
  • Using Makeshop's laser cutter: Max Cutting Dimensions are 14 x 9 "

Procedure

  1. Opened PDF obtained from boxmaker website in Inkscape
  2. Deleted the extraneous text
  3. Selected all and did the line draw thing
  4. Doesn't matter what the canvas size is in Inkscape, Raster Engrave is where that matters
  5. Print to Raster Engrave
  6. Set Settings to Speed:20, Power:100, Passes:3
  7. Put painters tape on both sides of the acrylic
  8. Make sure laser is up to 15mA
  9. Press "P" 4 times to outline the perimiter
  10. "Notch the corners with the laser's two fire buttons
  11. Press Play