Difference between revisions of "Omegix/USB Auth 1.7/Enclosure"

From Makers Local 256
Jump to: navigation, search
m (Procedure: added steps)
m (Procedure: added steps)
Line 13: Line 13:
 
# Delete the extraneous text
 
# Delete the extraneous text
 
# Doesn't matter what the canvas size is in Inkscape, Raster Engrave is where that matters
 
# Doesn't matter what the canvas size is in Inkscape, Raster Engrave is where that matters
 +
# If the object is grouped, select the object and Ungroup.  DO NOT DESELECT BEFORE MOVING TO THE NEXT STEP.
 
# Select the "Edit Paths by Node" tool, select the outline of box side
 
# Select the "Edit Paths by Node" tool, select the outline of box side
 
# Select the "Join selected endnodes with a new segment" button
 
# Select the "Join selected endnodes with a new segment" button

Revision as of 18:33, 22 October 2013

This page is for the creation of the Project Enclosure for the USB Auth 1.7 project.

  • Materials
    • 1/8 Inch Clear Acrylic.
      • 8 x 4.5 x 2.5 "
  • Project Files
  • Using Inkscape
  • Using Makeshop's laser cutter: Max Cutting Dimensions are 14 x 9 "

Procedure

  1. Opened PDF obtained from boxmaker website in Inkscape
  2. Delete the extraneous text
  3. Doesn't matter what the canvas size is in Inkscape, Raster Engrave is where that matters
  4. If the object is grouped, select the object and Ungroup. DO NOT DESELECT BEFORE MOVING TO THE NEXT STEP.
  5. Select the "Edit Paths by Node" tool, select the outline of box side
  6. Select the "Join selected endnodes with a new segment" button
    • The piece should now move as a whole
  7. Print to Raster Engrave
  8. Set Settings to Speed:20, Power:100, Passes:3
  9. Put painters tape on both sides of the acrylic
  10. Make sure laser is up to 15mA
  11. Press "P" 4 times to outline the perimiter
  12. "Notch the corners with the laser's two fire buttons
  13. Press Play