Difference between revisions of "SeeMeCNC H-1 3D Printer"

From Makers Local 256
Jump to: navigation, search
m (Added to the 3D Printer category.)
m (Software: added config.h)
Line 13: Line 13:
Config file for Sprinter (for H1): [[File:Configuration.h.zip]]
==Progress Log==
==Progress Log==

Revision as of 22:39, 30 September 2013

Initial testing and calibration
Born On:
23:34, 18 October 2012 (CDT)
Last Updated:
22:39, 30 September 2013 (CDT)


Early photo of the mostly-complete SeeMeCNC H-1 3D printer.

The SeeMeCNC H-1 3D printer is a thermoplastic extrusion-based rapid-prototyping machine modeled after the RepRap Huxley, which means it has a slightly smaller build area than the RepRap Mendel, but it can still get a lot done. The unique characteristic of the H-1 is that the parts are not printed (like most RepRap parts), but instead were created by using an injection-mold process, similar to the process LEGO uses to make its bricks and pieces. This means that once the molds were made for each of the pieces, the pieces are cheaper and quicker to fabricate. SeeMeCNC started up their project on IndieGoGo (similar to KickStarter), and requested donations to cover the costs of making the molds and designs. I made a donation of $100, which included the perk of receiving a complete set of H-1 plastic parts and hardware so that a full machine could be built, without the stepper motors or electronics.




Config file for Sprinter (for H1): File:Configuration.h.zip

Progress Log

16:38, 2 June 2013 (CDT): After a long hiatus, I'm starting the project back up again. So far, the printer is assembled and wired up, and is working with a few different host software applications. Extrusion has been mostly successful, but a few tweaks are needed. We're still looking into the best firmware/software combination to run the machine.