A couple of nights ago, Bob and I started playing with a Maker Bot one of the Makers Local 256 members left at the shop. I asked the member who owns it if I could try to get it working while he was gone on work travel. Of course he said “Yes”. He had been trying to get it to make a shot glass for a while. Bob and I started playing around. We installed the latest version of ReplicatorG and some new firmware. Bob then determined that the head needed to be about .6mm off the printing service. After he tagged me in, and I started playing with laying down a raft. After a few failed attempts where the head didn’t seem like it was moving up the Z-axis enough, I learned to set the Flow Rate of the plastic to 230 instead of 250 in skeinforge. Along with Bob’s findings we seemed to have found a very nice solution. I was able to make a coin, most of a shot glass (something happen 3/4 the way through), and a companion cube.
