View source for CR10 3D Printer Clone

{{Project|Creator=Neal
|Status=<onlyinclude> Operational </onlyinclude>                                <!--LEAVE ONLYINCLUDES FOR STATUS HACK--> 
|Born On=10:24, 28 July 2021 (CDT)                                                                  <!--DO NOT EDIT -->
|Last Updated={{#time: H:i, d F Y| {{REVISIONTIMESTAMP}} }} (CDT)              <!--DO NOT EDIT -->
}}

==Overview==
The following settings were provided by Neal.
=== ABS Settings ===
* Printer bed at 80
* extruder at 240.
* low res (.28mm layer, .4mm walls, 2 perimeters 20% hex infill) 
* 3 layer 10mm skirt has been used, but lately fine without it


[[Category:3D printer]]                                                  <!--MAKE AS MANY CATEGORIES AS YOU NEED-->