Difference between revisions of "Robotec 100W Laser/RepairTimeline"
From Makers Local 256
Enabrintain (Talk | contribs) (→Diagnosis) |
Enabrintain (Talk | contribs) (→updated) |
||
(One intermediate revision by one user not shown) | |||
Line 9: | Line 9: | ||
** This replacement is contingent on photos of the defective tube's destruction | ** This replacement is contingent on photos of the defective tube's destruction | ||
* On 15DEC17, the laser tube was permanently disabled in a manner allowing serial number identification. Photos of the destroyed tube were emailed to the manufacturer. | * On 15DEC17, the laser tube was permanently disabled in a manner allowing serial number identification. Photos of the destroyed tube were emailed to the manufacturer. | ||
− | ** The manufacturer replied that the replacement tube is being shipped via DHL. ETA | + | ** The manufacturer replied that the replacement tube is being shipped via DHL. Shipping ETA 21DEC17. |
+ | ** Current plans are to meet at shop on Thursday night and install the new tube. | ||
+ | * On 22DEC17 the new tube arrived, and was installed | ||
+ | ** We decided to only run the laser at a max of 80% power until more diagnostics could be run. | ||
+ | ** The laser is cutting again, however we're not sure if its giving us its best effort. | ||
== Next Steps == | == Next Steps == | ||
− |
Latest revision as of 12:35, 9 January 2018
Diagnosis
- Laser cutting power was noticeably less, with reports of multiple passes being necessary to cut through material starting as early as 25NOV17.
- On 12DEC17, a concerted effort to collect evidence of the low power phenomenon was pursued.
- The problem was verified, and the laser's mirrors were examined for alignment issues.
- No problems with the mirrors were identified, so it was decided to contact the manufacturer.
- On 13DEC17, the manufacturer was emailed, they requested photos of various parts of the laser to determine proper installation.
- The requested photos were provided.
- On 14DEC17, the manufacturer determined that the problem is a defective laser tube and offered to replace it under warranty
- This replacement is contingent on photos of the defective tube's destruction
- On 15DEC17, the laser tube was permanently disabled in a manner allowing serial number identification. Photos of the destroyed tube were emailed to the manufacturer.
- The manufacturer replied that the replacement tube is being shipped via DHL. Shipping ETA 21DEC17.
- Current plans are to meet at shop on Thursday night and install the new tube.
- On 22DEC17 the new tube arrived, and was installed
- We decided to only run the laser at a max of 80% power until more diagnostics could be run.
- The laser is cutting again, however we're not sure if its giving us its best effort.