Millard fillmore
From Makers Local 256
content goes here brokentrace
thoughts
- cheap
- cutting area 12x12x6
- equal length parts for lead screws, and linear shafts
- few custom parts as possible
- few wood cuts as possible or in small enough sections machine can cut itself
- single pcb for control 4x6 inch in size
- find good power supply for everything
- tweak 5d reprap firmware to control spindle and allow for tool changes
- cuts for endstops and encoders
- possibly go to higher thread per inch lead screws
- work on x,y,z flexing
- write gcode for zeroing out cut area
- larger z platform for holding different tools, spindle, extruder, laser, router, dremel etc
- figure out good way to mount bushings and leadscrew nuts.
