Bigass Mill

From Makers Local 256
Jump to: navigation, search

This page is about the very large, hard to move mill.

POC

This item is perma-loaned to Makers Local 256 by Scott (not preaux).

State

Mill was not working as of 2017.05.03 (earlier, but this is the first put into the wiki).

  • According to Wes, the mill would need new X and Y nuts, which would cost about $150 each to replace.
    • Wes is going to provide a reference to this part to Preaux, maybe he can find a source for it that is cheaper
  • According to wes, once the nuts are replaced it should work excellently.

Repair History and Notes

  • Daniel V. fixed the pulley mounted to the motor shaft around 2017.04/05

Value