Cerealbot/Financial
From Makers Local 256
Project Cost Breakdown
Does not include existing things that I own which have been purposed for this project.
dd-mm-yyyy
- 28-11-2014
- Printrbot Simple Metal Unassembled - $539.00
- Filament - $22.50
- 14-12-2014
- Kapton Tape - $17.99
- Extruder Fan - $6.13
- Extruder Fan 2 - $5.95
- 8 Channel Relay - $9.99
- Went missing x(
- 12V Power Supply - $22.14
- Hot Bed - $19.99
- 25-1-2015
- 12V Relays for hotbed - $13.60
- Raspberry Pi to run octoprint - $33.19
- 5V relays to upgrade killswitch - $11.99
- Kapton Tape, because its awesome - $25.95
- 0.4mm drill bits to clean clogged nozzles - $10.99
- 4x Futaba Servos to make armatures that clean the print surface - $51.52
- More x-y axis belt, because I now consider it ablative - $25.00
- Mini breadboards to wire up test circuits - $6.95
- Wire for breadboards - $4.33
- 30-4-2015
- Copper tape for hotbed testing - $15.96
- PEI sheet for alternate hotbed surface - $17.24
- 24V PSU for hotbed - $24.99
- 2x NEMA cables for the PSUs - $9.90
- Tape for PEI - $4.88
- 7-5-2015
- Silicon mat for hotbed - $8.08
- 21-5-2015
- 5-6-2015
- SD Card for RPi - $8.85
- RPi V2 As new server - $45.99
- RC power plugs - $7.82
- Heatshrink - $8.49
- Logic voltage converter - $6.99
- USB FTDI breakout - $6.99
- Jumper terminator, male - $5.50
- Jumper terminator, female - $5.72
- 50' Servo wire - $15.01
- 100pcs servo connector housing - $6.20
- Crimper for Dupont pins - $19.00
Project Cost: $1097.62