Difference between revisions of "Cerealbot"
From Makers Local 256
m (still setting up page) |
m (updated status) |
||
| Line 1: | Line 1: | ||
{{Project|Creator=ctag | {{Project|Creator=ctag | ||
| − | |Status=<onlyinclude> | + | |Status=<onlyinclude> Constructing Train_Rec ABP </onlyinclude> <!--LEAVE ONLYINCLUDES FOR STATUS HACK--> |
|Born On=23:32, 13 December 2014 (CST) <!--DO NOT EDIT --> | |Born On=23:32, 13 December 2014 (CST) <!--DO NOT EDIT --> | ||
|Last Updated={{#time: H:i, d F Y| {{REVISIONTIMESTAMP}} }} (CDT) <!--DO NOT EDIT --> | |Last Updated={{#time: H:i, d F Y| {{REVISIONTIMESTAMP}} }} (CDT) <!--DO NOT EDIT --> | ||
| Line 13: | Line 13: | ||
=== Trainrec Build System === | === Trainrec Build System === | ||
| + | |||
| + | The testbed for train_rec was a success. Rather than use the length of the pop-bar as a lever to pry the piece off of the bed, I think its better to twist the bar along the length to push the 3d printed part up. | ||
| + | |||
| + | Milling the "production/testing" bed is next on the list. | ||
== Current Configuration == | == Current Configuration == | ||
Revision as of 14:35, 10 January 2015
|
Creator: |
Contents
[hide]Overview
I can haz printr.
Software
Slic3r Config
Trainrec Build System
The testbed for train_rec was a success. Rather than use the length of the pop-bar as a lever to pry the piece off of the bed, I think its better to twist the bar along the length to push the 3d printed part up.
Milling the "production/testing" bed is next on the list.
Current Configuration
Plans
Printed Upgrades
Printed Parts
External Resources
ctag's G+ Image Album Printrbot initial config guide Protoparadigm plastic I'm interested in
