Difference between revisions of "Cerealbot"
From Makers Local 256
m (changed abp name) |
m (added printr ip address) |
||
| Line 9: | Line 9: | ||
== Software == | == Software == | ||
| + | |||
| + | IP addr: 10.56.1.60 | ||
=== Slic3r Config === | === Slic3r Config === | ||
Revision as of 22:08, 17 January 2015
|
Creator: |
Contents
[hide]Overview
I can haz printr.
Software
IP addr: 10.56.1.60
Slic3r Config
Cereally Automated Build System
The testbed for train_rec was a success. Rather than use the length of the pop-bar as a lever to pry the piece off of the bed, I think its better to twist the bar along the length to push the 3d printed part up.
Milling the "production/testing" bed is next on the list.
Current Configuration
Plans
Printed Upgrades
Printed Parts
External Resources
ctag's G+ Image Album Printrbot initial config guide Protoparadigm plastic I'm interested in
