Difference between revisions of "Omegix/Home Automation"
From Makers Local 256
(→Garage Door Opener: updating status of project) |
(→Physical Resources: adding tilt sensor) |
||
| Line 7: | Line 7: | ||
* 2 x [http://smile.amazon.com/gp/product/B00E1L86EQ?psc=1&redirect=true&ref_=oh_aui_detailpage_o01_s00 120V Isolated Relay] | * 2 x [http://smile.amazon.com/gp/product/B00E1L86EQ?psc=1&redirect=true&ref_=oh_aui_detailpage_o01_s00 120V Isolated Relay] | ||
* 1 x [http://smile.amazon.com/Monoprice-Z-Wave--Wall-Relay-Module/dp/B00V5IQATG/ref=sr_1_8?s=hi&ie=UTF8&qid=1444839006&sr=8-8&keywords=monoprice+relay Monoprice Zwave Dual Relay] | * 1 x [http://smile.amazon.com/Monoprice-Z-Wave--Wall-Relay-Module/dp/B00V5IQATG/ref=sr_1_8?s=hi&ie=UTF8&qid=1444839006&sr=8-8&keywords=monoprice+relay Monoprice Zwave Dual Relay] | ||
| + | * 2 x [http://www.monoprice.com/product?p_id=11987 Zwave Garage Door Tilt Sensor] | ||
| + | ** Status: Awaiting delivery of 1 tilt sensor to prove concept before ordering more. | ||
* Project Enclosure | * Project Enclosure | ||
* Standard ungrounded electrical cord | * Standard ungrounded electrical cord | ||
Revision as of 11:08, 16 October 2015
Garage Door Opener
Pictured Above: Monoprice Dual Relay Controller wired to two 120 V isolated relays. Resting inside the enclosure is a Aeon Z-wave minimote (remote) used for testing. Both the relay controller and the minimote are joined to a Zwave networked controlled by a SmartThings v2 hub. A SmartApp (TM) has been setup on the hub to react in the following way: When Button 1 is pressed, Relay 1 is toggled. When Button 2 is pressed, Relay 2 is toggled.
Physical Resources
- 2 x 120V Isolated Relay
- 1 x Monoprice Zwave Dual Relay
- 2 x Zwave Garage Door Tilt Sensor
- Status: Awaiting delivery of 1 tilt sensor to prove concept before ordering more.
- Project Enclosure
- Standard ungrounded electrical cord
- electrical twist connectors
- Wire from a computer power supply
Online Resources
- Raspberry Pi as a SmartThings endpoint: https://github.com/nicholaswilde/smartthings/tree/master/device-types/raspberry-pi
- Would have to modify code to set a pin on the GPIO rather than just read it
- Using an off the shelf Zwave 120V loaded switch in tied to a 120V isolated relay: http://www.instructables.com/id/Z-Wave-Garage-Door-Opener-Switch/
- http://forum.micasaverde.com/index.php?topic=24937.0
- 120V isolated relay on a slow boat from china: http://www.ebay.com/itm/HH52P-110-120VAC-Coil-DPDT-Electromagnetic-Power-Relay-WD-/181722024869
- SmartThings Dual Relay Control DeviceType
