Difference between revisions of "Beehive Monitor"
From Makers Local 256
(→Artik053 to ADS1234: adding pinouts) |
(→Artik053 to ADS1234: adding pinout) |
||
| Line 29: | Line 29: | ||
* ADS-Pin08-A0 to Artik-Pin58-XGPIO12 | * ADS-Pin08-A0 to Artik-Pin58-XGPIO12 | ||
** Purpose: This will select the MUX for which bridge input is being read | ** Purpose: This will select the MUX for which bridge input is being read | ||
| + | * ADS-Pin28-DOUT to Artik-Pin68-GPIO1 | ||
| + | ** Purpose: For the Artik board to read in the digital hi\low signals from the ADS1234 | ||
[[Category:Bees]] <!--MAKE AS MANY CATEGORIES AS YOU NEED--> | [[Category:Bees]] <!--MAKE AS MANY CATEGORIES AS YOU NEED--> | ||
Revision as of 18:56, 23 September 2018
|
Creator: |
Overview
Project page for monitoring beehives
Capabilities
- Weigh the beehive
Components
- Samsung Artik Board 053: https://media.digikey.com/pdf/Data%20Sheets/Samsung%20PDFs/ARTIK_053_053s_DS_11-23-17.pdf
- A2D Chip For Bridge Sensors (ADS1234, 28 pin): http://www.ti.com/lit/ds/symlink/ads1232.pdf
Bridge to ADS1234
- Bridge1 to ADS-Pin11-AINP1
- Bridge1 to ADS-Pin18-AINP2
Artik053 to ADS1234
- ADS-Pin01-DVDD to Artik-Pin32-DC_5V_12V
- ADS-Pin02-DGND to Artik-Pin20-GND
- ADS-Pin05-DGND to Artik-Pin20-GND
- ADS-Pin06-DGND to Artik-Pin20-GND
- ADS-Pin03-CLKIN to Artik-Pin39-XGPIO28
- Intent: This will cycle the clock on the ADS to instruct it to bit shift?
- ADS-Pin07-A1 to Artik-Pin20-GND
- Intent: There will never be more than two sets of bridges to read in this design. Set to 0 so that ADS-Pin08-A0 will always select between two MUX inputs vs. four MUX Inputs.
- ADS-Pin08-A0 to Artik-Pin58-XGPIO12
- Purpose: This will select the MUX for which bridge input is being read
- ADS-Pin28-DOUT to Artik-Pin68-GPIO1
- Purpose: For the Artik board to read in the digital hi\low signals from the ADS1234
