Difference between revisions of "Shop Table"
From Makers Local 256
m (→Basic Frame: add image comment) |
(→Materials List: make the design simpler) |
||
| Line 10: | Line 10: | ||
==Materials List== | ==Materials List== | ||
* 2"x4"x40" [6] (legs) | * 2"x4"x40" [6] (legs) | ||
| − | * 2"x4"x47.5" [ | + | * 2"x4"x47.5" [4] (short horizontal supports) |
| − | * 2"x4"x44.5" [ | + | * 2"x4"x44.5" [4] (middle horizontal supports) |
| − | * 2"x4"x92.5" [ | + | * 2"x4"x92.5" [4] (long horizontal supports) |
* 4'x8'x0.75" MDF [1] (base table surface) | * 4'x8'x0.75" MDF [1] (base table surface) | ||
* 4'x8' dry-erase showerboard material [1] (replacable top surface) | * 4'x8' dry-erase showerboard material [1] (replacable top surface) | ||
| − | |||
| − | |||
==Assembly== | ==Assembly== | ||
Revision as of 13:02, 2 May 2009
|
Creator: |
Contents
[hide]Overview
This is the official design for stool height shop tables with dry-erasable tops. The end cost is targeted to be somewhere around $80.
Materials List
- 2"x4"x40" [6] (legs)
- 2"x4"x47.5" [4] (short horizontal supports)
- 2"x4"x44.5" [4] (middle horizontal supports)
- 2"x4"x92.5" [4] (long horizontal supports)
- 4'x8'x0.75" MDF [1] (base table surface)
- 4'x8' dry-erase showerboard material [1] (replacable top surface)
Assembly
Basic Frame
- Place the long MDF supports 44.5" apart.
- Cap them with the short MDF supports.
- Drill 2 holes for each joint, countersink them, and secure them with screws.
- Drill 4 holes near the top of each leg and countersink them.
- Put the legs in the proper positions and secure them with 4 screws each (see image).
- Place the middle MDF supports on either side of the middle legs.
- Drill 2 holes for each middle MDF support joint and countersink the holes.
- Secure all remaining joints with 2 screws.
