Difference between revisions of "Shop Table"
From Makers Local 256
(→Materials List: make the design simpler) |
(→Basic Frame: update for simplified design) |
||
| Line 17: | Line 17: | ||
==Assembly== | ==Assembly== | ||
| − | === | + | ===Support Frame [2]=== |
| − | # Place the long | + | # Place the long horizontal supports 44.5" apart. |
| − | # Cap them with the short | + | # Cap them with the short horizontal supports. |
| + | # Center the two middle horizontal supports 3.5" apart between the long horizontal supports. | ||
# Drill 2 holes for each joint, countersink them, and secure them with screws. | # Drill 2 holes for each joint, countersink them, and secure them with screws. | ||
| − | # Drill 4 holes | + | # Drill 4 holes for securing the legs and countersink them. |
| − | + | # Secure all joints with 2 screws. | |
| − | + | ||
| − | + | ||
| − | # Secure all | + | |
===Shelf Frame=== | ===Shelf Frame=== | ||
Revision as of 13:31, 2 May 2009
|
Creator: |
Contents
[hide]Overview
This is the official design for stool height shop tables with dry-erasable tops. The end cost is targeted to be somewhere around $80.
Materials List
- 2"x4"x40" [6] (legs)
- 2"x4"x47.5" [4] (short horizontal supports)
- 2"x4"x44.5" [4] (middle horizontal supports)
- 2"x4"x92.5" [4] (long horizontal supports)
- 4'x8'x0.75" MDF [1] (base table surface)
- 4'x8' dry-erase showerboard material [1] (replacable top surface)
Assembly
Support Frame [2]
- Place the long horizontal supports 44.5" apart.
- Cap them with the short horizontal supports.
- Center the two middle horizontal supports 3.5" apart between the long horizontal supports.
- Drill 2 holes for each joint, countersink them, and secure them with screws.
- Drill 4 holes for securing the legs and countersink them.
- Secure all joints with 2 screws.
