Difference between revisions of "BPM Personal Modeler 2100"
From Makers Local 256
(Added Primer Link) |
(Added powerpoint abour BPM) |
||
| Line 31: | Line 31: | ||
==Links== | ==Links== | ||
* [[http://www.mne.psu.edu/lamancusa/rapidpro/primer/chapter2.htm Rapid Prototyping Primer ]] | * [[http://www.mne.psu.edu/lamancusa/rapidpro/primer/chapter2.htm Rapid Prototyping Primer ]] | ||
| + | |||
== Files == | == Files == | ||
* [[File:US4665492.pdf]] | * [[File:US4665492.pdf]] | ||
* [[File:US5216616.pdf]] | * [[File:US5216616.pdf]] | ||
* [[File:US5555176.pdf]] | * [[File:US5555176.pdf]] | ||
| − | + | * [[File:BPM.pdf]] | |
[[Category:Rapid Prototyping, MakerBot]] <!--MAKE AS MANY CATEGORIES AS YOU NEED--> | [[Category:Rapid Prototyping, MakerBot]] <!--MAKE AS MANY CATEGORIES AS YOU NEED--> | ||
Revision as of 16:44, 27 September 2009
|
Creator: |
Overview
We were donated a 3D wax printer, BPM Personal Modeler 2100 by Scott Savage of Savage Innovations. This page is a clearinghouse to hold knowledge about this printer as we dig it up and notes/coordination of the repair effort.
Known Issues
- Wax not streaming out of head when printing. Will flush the wax, but not print with it.
Equipment Details
- Included computer runs DOS, and the software that operates the machine runs on DOS
- The motor control boards interface with a custom ISA controller in the machine
People
- Lead Hackers (Contact before futzing with the hardware or software)
- Justin(Ratmandu)
- Tim(crashcartpro)
- Researchers
- Mog
- Strages
- Bob
