Cerealbot

Creator: ctag Status: Constructing Train_Rec ABP Born On: 23:32, 13 December 2014 (CST) Last Updated: 14:35, 10 January 2015 (CDT)

Overview

I can haz printr.

Software

Trainrec Build System

The testbed for train_rec was a success. Rather than use the length of the pop-bar as a lever to pry the piece off of the bed, I think its better to twist the bar along the length to push the 3d printed part up.

Milling the "production/testing" bed is next on the list.

External Resources

ctag's G+ Image Album Printrbot initial config guide Protoparadigm plastic I'm interested in