Beehive Monitor

Creator: Omegix Status: Your Status Born On: 21:11, 18 September 2018 (CDT) Last Updated: 21:52, 18 September 2018 (CDT)

Overview

Project page for monitoring beehives

Capabilities

• Weigh the beehive

Components

• Samsung Artik Board 053: https://media.digikey.com/pdf/Data%20Sheets/Samsung%20PDFs/ARTIK_053_053s_DS_11-23-17.pdf
• A2D Chip For Bridge Sensors (ADS1234, 28 pin): http://www.ti.com/lit/ds/symlink/ads1232.pdf

Artik053 to ADS1234

• ADS-Pin01-DVDD to Artik-Pin32-DC_5V_12V
• ADS-Pin02-DGND to Artik-Pin20-GND
• ADS-Pin05-DGND to Artik-Pin20-GND
• ADS-Pin06-DGND to Artik-Pin20-GND
• ADS-Pin03-CLKIN to Artik-Pin39-XGPIO28
  • Intent: This will cycle the clock on the ADS to instruct it to bit shift?
• ADS-Pin07-A1 to Artik-Pin20-GND
  • Intent: There will never be more than two sets of bridges to read in this design. Set to 0 so that ADS-Pin08-A0 will always select between two MUX inputs vs. four MUX Inputs.
• ADS-Pin08-A0 to Artik-Pin58-XGPIO12
  • Purpose: This will select the MUX for which bridge input is being read