Difference between revisions of "Omegix/Home Automation/Sandusky"
From Makers Local 256
(adding home device information) |
(adding minimote notes) |
||
| Line 2: | Line 2: | ||
* Started with a Samsung Smarthub 2.0. Difficult to program. | * Started with a Samsung Smarthub 2.0. Difficult to program. | ||
* Currently using HomeSeer Hometroller ZS2 | * Currently using HomeSeer Hometroller ZS2 | ||
| + | |||
= Living Room = | = Living Room = | ||
== Lights == | == Lights == | ||
| Line 11: | Line 12: | ||
** Ebay: Used, $20 each | ** Ebay: Used, $20 each | ||
* HomePro ZDW100 (2 of 2) | * HomePro ZDW100 (2 of 2) | ||
| + | |||
| + | = Remotes = | ||
| + | * Aeon Minimote Remote Controller | ||
| + | ** This does not work with homeseer out of the box, firmware has to be upgraded and steps followed: | ||
| + | *** http://67.217.100.102/showthread.php?p=1168034 | ||
| + | **** The source page for this was some guys private bulletin board, so I'm copying his article to the wiki | ||
| + | ***** [[Omegix/Home_Automation/Minimote/Miniremote Two Ways to install it]] | ||
Revision as of 11:08, 24 January 2016
Contents
[hide]Zwave Controller
- Started with a Samsung Smarthub 2.0. Difficult to program.
- Currently using HomeSeer Hometroller ZS2
Living Room
Lights
- HomePro ZDW120
- Ebay: Used, $20
- Learned that the pairing information is stored on the zwave device, and that the device must receive a leave-network command from a smart hub before it can be added to a new z-wave network.
- Add or remove to z-wave network by turning on and then off. Same to instruct it to leave the network, after the controller has issued the leave-network command
- HomePro ZDW100 (1 of 2)
- Ebay: Used, $20 each
- HomePro ZDW100 (2 of 2)
Remotes
- Aeon Minimote Remote Controller
- This does not work with homeseer out of the box, firmware has to be upgraded and steps followed:
- http://67.217.100.102/showthread.php?p=1168034
- The source page for this was some guys private bulletin board, so I'm copying his article to the wiki
- http://67.217.100.102/showthread.php?p=1168034
- This does not work with homeseer out of the box, firmware has to be upgraded and steps followed:
