Difference between revisions of "X10 Ackis Module/ML256"
From Makers Local 256
(added supporting information) |
m (added more insight) |
||
| Line 6: | Line 6: | ||
* Wall Module advertised as supporting flourescent bulbs was not able to supply enough power to the ballasts to get the lights running. Need to research as to why. Could be a bad X10 module. [[User:Omegix|Omegix]] 12:43, 12 February 2010 (CST) | * Wall Module advertised as supporting flourescent bulbs was not able to supply enough power to the ballasts to get the lights running. Need to research as to why. Could be a bad X10 module. [[User:Omegix|Omegix]] 12:43, 12 February 2010 (CST) | ||
** http://www.x10.com/support/support_q3.htm | ** http://www.x10.com/support/support_q3.htm | ||
| + | ** Upon initial inspection, only two wires seemed to be present in the light switch box. The unit requires a Neutral connection to work. It's possible this wire is attached to the casing of the box. It's also possible due to the age of the building that the neutral line was never run. | ||
Revision as of 17:27, 16 February 2010
This page is to mark Makers Local 256 specific progress of X10 installation
- Confirmed\Learned the following
- Wall Module advertised as supporting flourescent bulbs was not able to supply enough power to the ballasts to get the lights running. Need to research as to why. Could be a bad X10 module. Omegix 12:43, 12 February 2010 (CST)
- http://www.x10.com/support/support_q3.htm
- Upon initial inspection, only two wires seemed to be present in the light switch box. The unit requires a Neutral connection to work. It's possible this wire is attached to the casing of the box. It's also possible due to the age of the building that the neutral line was never run.
