Difference between revisions of "User:Bobbytables/LaserLog"
From Makers Local 256
Bobbytables (Talk | contribs) (Bobby's Laser Log so I don't forget stuff) |
Bobbytables (Talk | contribs) m (Added) |
||
| Line 5: | Line 5: | ||
*If you're lasering larger piece (>12") it might be useful to do the fine details in a first-pass layer, and then the overall outline as a last layer as board might curl up slightly after a large section is cut loose. | *If you're lasering larger piece (>12") it might be useful to do the fine details in a first-pass layer, and then the overall outline as a last layer as board might curl up slightly after a large section is cut loose. | ||
*When focused the FLC1490 can cut beams as thin as 0.05" but the 0.02" beams just got burnt. When the focus was a bit off the 0.05" beams were burnt. The 0.05" beams are too thin for structural support, but make nice internal members. | *When focused the FLC1490 can cut beams as thin as 0.05" but the 0.02" beams just got burnt. When the focus was a bit off the 0.05" beams were burnt. The 0.05" beams are too thin for structural support, but make nice internal members. | ||
| − | *Making interlocking joints on an outside-corner without compensating for the removed material | + | *Making interlocking joints on an outside-corner without compensating for the removed material fit well side-to-side, but the tongues might be a bit short. Trying to do the same thing for tendons that fit into a rectangular hole is a bit tight, but nothing a bit of filing can't fix. |
*Exporting from Draftsight to R2000-2002 ACSII Drawing (*.dxf) carries across the scale in inches just fine. | *Exporting from Draftsight to R2000-2002 ACSII Drawing (*.dxf) carries across the scale in inches just fine. | ||
*Make sure to explode text to a series of lines before exporting. | *Make sure to explode text to a series of lines before exporting. | ||
Revision as of 14:13, 24 November 2015
2015-11-21
Cut 3/16 Luan on the [FLC1490_Laser_Cutter].
- Speed 5, power 100% cuts almost everything except for a few stubborn patches of filler/glue, but those can be finished with a knife.
- Cutting all the way through the piece in the first pass allows the smoke to be sucked from the bottom, decreasing the smoke in the laser cutter greatly.
- If you're lasering larger piece (>12") it might be useful to do the fine details in a first-pass layer, and then the overall outline as a last layer as board might curl up slightly after a large section is cut loose.
- When focused the FLC1490 can cut beams as thin as 0.05" but the 0.02" beams just got burnt. When the focus was a bit off the 0.05" beams were burnt. The 0.05" beams are too thin for structural support, but make nice internal members.
- Making interlocking joints on an outside-corner without compensating for the removed material fit well side-to-side, but the tongues might be a bit short. Trying to do the same thing for tendons that fit into a rectangular hole is a bit tight, but nothing a bit of filing can't fix.
- Exporting from Draftsight to R2000-2002 ACSII Drawing (*.dxf) carries across the scale in inches just fine.
- Make sure to explode text to a series of lines before exporting.
