Omegix/Home Automation/Sandusky

Zwave Controller

• Started with a Samsung Smarthub 2.0. Difficult to program.
• Currently using HomeSeer Hometroller ZS2

Living Room

Lights

• HomePro ZDW120
  • Ebay: Used, $20
  • Learned that the pairing information is stored on the zwave device, and that the device must receive a leave-network command from a smart hub before it can be added to a new z-wave network.
  • Add or remove to z-wave network by turning on and then off. Same to instruct it to leave the network, after the controller has issued the leave-network command
• HomePro ZDW100 (1 of 2)
  • Ebay: Used, $20 each
• HomePro ZDW100 (2 of 2)

Remotes

• Aeon Minimote Remote Controller
  • This does not work with homeseer out of the box, firmware has to be upgraded and steps followed:
    • http://67.217.100.102/showthread.php?p=1168034
      • The source page for this was some guys private bulletin board, so I'm copying his article to the wiki
        • Omegix/Home_Automation/Minimote/Miniremote Two Ways to install it