Bigass Mill
From Makers Local 256
This page is about the very large, hard to move mill.
Contents
[hide]POC
This item is perma-loaned to Makers Local 256 by Scott (not preaux).
State
Mill was not working as of 2017.05.03 (earlier, but this is the first put into the wiki).
- According to Wes, the mill would need new X and Y nuts, which would cost about $150 each to replace.
- Wes is going to provide a reference to this part to Preaux, maybe he can find a source for it that is cheaper
- According to wes, once the nuts are replaced it should work excellently.
Repair History and Notes
- Daniel V. fixed the pulley mounted to the motor shaft around 2017.04/05
Value
- See Inventory
