Difference between revisions of "Omegix/USB Auth 1.7/Enclosure"
From Makers Local 256
(creating page for enclosure) |
m (added steps) |
||
| Line 8: | Line 8: | ||
* Using Inkscape | * Using Inkscape | ||
* Using Makeshop's laser cutter: Max Cutting Dimensions are 14 x 9 " | * Using Makeshop's laser cutter: Max Cutting Dimensions are 14 x 9 " | ||
| + | |||
| + | == Procedure == | ||
| + | # Opened PDF obtained from boxmaker website in Inkscape | ||
| + | # Deleted the extraneous text | ||
| + | # Selected all and did the line draw thing | ||
| + | # Doesn't matter what the canvas size is in Inkscape, Raster Engrave is where that matters | ||
| + | # Print to Raster Engrave | ||
| + | # Set Settings to Speed:20, Power:100, Passes:3 | ||
| + | # Put painters tape on both sides of the acrylic | ||
| + | # Make sure laser is up to 15mA | ||
| + | # Press "P" 4 times to outline the perimiter | ||
| + | # "Notch the corners with the laser's two fire buttons | ||
| + | # Press Play | ||
Revision as of 19:10, 1 October 2013
This page is for the creation of the Project Enclosure for the USB Auth 1.7 project.
- Materials
- 1/8 Inch Clear Acrylic.
- 8 x 4.5 x 2.5 "
- 1/8 Inch Clear Acrylic.
- Project Files
- Using Inkscape
- Using Makeshop's laser cutter: Max Cutting Dimensions are 14 x 9 "
Procedure
- Opened PDF obtained from boxmaker website in Inkscape
- Deleted the extraneous text
- Selected all and did the line draw thing
- Doesn't matter what the canvas size is in Inkscape, Raster Engrave is where that matters
- Print to Raster Engrave
- Set Settings to Speed:20, Power:100, Passes:3
- Put painters tape on both sides of the acrylic
- Make sure laser is up to 15mA
- Press "P" 4 times to outline the perimiter
- "Notch the corners with the laser's two fire buttons
- Press Play
